Lure Head 3D

J7W1 Shinden Restoration 3D Design Tips

Archive for July, 2009

A little old-fashioned hangar

Posted by kikakuya on July 7, 2009


This is completion of framework. The iron frame is united to the outside wall and the roof. If the size has no mistake, it must be fit. This moment is strained most on an actual architecture. It is the same strained for 3D. As I thought, some mistakes were there. Then, the position of some pillars has been adjusted. The indoor lighting position is adjusted before the lighting window of the roof is put up. This is the timing for  “Electric appliances store”. Rendering the hangar where the completion of framework was completed.  A little old-fashioned hangar has been being gradually completed.
Next time, let’s approach the elaboration and the outside environment etc. of an internal rig (equipment and others) and the outside wall.

0702

Posted in 3D, Imagination, J7W1 Shinden, Mapping, Tips | Leave a Comment »

Adjustment of how to be seen

Posted by kikakuya on July 7, 2009


06284

The size of the object seems to be true if an object of comparison thing is there.   Size of window pane, number of boarding steps, and car license plate, etc. were adjusted.

Posted in 3D, Imagination, J7W1 Shinden, Mapping, Tips | Leave a Comment »

What kind of hangar do you have?

Posted by kikakuya on July 7, 2009


This time is for modeling of the outside wall and the roof. They have to be fit completely against the iron frame that was installed. The concepts for the hangar roughly are as follows. The front entrance is wide, and the front has door cases on a right and left sliding door and both sides. The height of the building is about 7m. The wall has a big window for the lighting. The lighting window is put up to the roof. The window pane is partially opened. The glass adopts the becoming cloudy glass in principle. Lighting equipment is put up internally. The maintenance machines and some equipments for repair are set up. The basic structure like the below was planned by the above-mentioned setting.

06243

Adjustment for them will be going to step by step from next post.

Posted in 3D, Imagination, J7W1 Shinden, Mapping, Tips | Leave a Comment »

Design of hangar

Posted by kikakuya on July 7, 2009


A small hangar is planned for Shinden. The area of the hangar is just a size that J7w1 Shinden completely enters in. First of all, the structure of the iron frame was planned.  Because a modern hangar is not suited for Shinden,legacy type is good image. They are the roughly following feeling.

0702bone

The prototype of the roof and the outside wall will be made next time.

Posted in 3D, Imagination, J7W1 Shinden, Mapping, Tips | Leave a Comment »